Lexia-3 for Citroen and Peugeot

If you are very confused about using which kind of the diagnostic tool for your vehicle, don’t feel alone! Here is a tool lexia-3 are suitable for you if you have Citroen and Peugeot car.
This tool has the latest version PP2000/LEXIA-3 Interface, which about Lexia 3 citroen and lexia-3 peugeot! The diagnostics software allows you to perform complete diagnostics of all from 1995 until present models. Diagnostics is performed via OBD2 connector (which is located near steering wheel) or via manufacturer-specific connector (only older cars, pre-2001).
Supported functions
The software performs nearly ALL the functions like the original dealer diagnostic tool, which didn’t like other universal car scanner tools which only read fault codes obd2. Our diagnostic interface contains K-Line multiplexor, CAN-BUS interfaces and SAE J1850 bus (both PWM and VPW).

lexia-3
The following diagnostic functions are supported:
Unlike other universal car scanner tools which only read fault codes, this software performs nearly all the functions like the original dealer diagnostic tool. Our diagnostic interface contains K-Line multiplexor, CAN-BUS interfaces and SAE J1850 ford vcm bus (both PWM and VPW).
1. Read identification
Show complete identification of control unit, for example, part number, software/hardware version, manufacturer, etc…
2. Read fault codes
Show all stored and pending fault codes with complete description (for example. “Rail pressure – too low pressure”).
Program supports report printing or copy to clipboard.
3. Clear fault codes
It can clears all stored fault codes and other diagnostic information.
4. Auto-scan (complete car scan/test)
Detects all ECUs (electronic control units) installed in car and reads all diagnostic fault codes.
5. Measured Values
Program displays live Data like Engine Speed, Battery voltage, Oxygen Sensor, Coolant Temperature, etc. Values can be displayed in graph, 9 values at once, or full listing (all measured values). Logging to file is also supported, which allows offline analysis.
6. Actuator test
Actuator test activates particular actuator (e.g. turn on fuel pump, lock/unlock wheel, lock/unlock doors, cut off fuel, etc…)
7. Programming functions/Adaptation
This feature is of great importance in all vehicles because systems like Engine control units, Immobilizers, Airbags, Alarms, Body Control Units, and some others, require you to perform reset or programming procedures after car repair is done or even configuration after replacing broken Control Unit.
BMW OPPS

Hardware and software requirements
The Software of the tools need at least Intel Celeron/Pentium III 400 MHz, 128 MB RAM, 50MB free HDD space and USB 1.1 port (USB 2.0 recommended) and Microsoft Windows 98 SR2/2000/XP with the latest service pack installed.

http://dentalequipment.blogbaker.com/2011/11/20/lexia-3-for-citroen-and-peugeot

Laisser un commentaire